how to start precor treadmill

For treadmills: Locate at least 40 inches (1 meter) away from walls or furniture on either side of the treadmill, and at least 80 inches (2 meters) away from objects behind the treadmill. Important: These location standards should also be used when positioning equipment away from sources of heat, such as radiators, heat registers, and stoves.

Press Start to begin the exercise. On Precor Treadmills: Only 9.33 and 9.35 have 2 Custom programs included in their consoles. Select the User Key, then the Variety Key. The workouts save your preferences for incline and speed while you exercise. Each segment has a predefined length of 1 minute.

Use the power switch beneath the front panel to turn. the treadmill Off. Make sure the treadmill is located away from heating. ducts. Wait a few minutes. Make sure the magnetic safety key. Push the red reset button, and then turn the treadmill On. Check the display to verify that the Precor banner is.

· If you still see the “stop key” message, press on the red plastic stop button. Get your ear close to it, and listen to it carefully. Every time you press it, you should hear/feel a small click, like a button being pressed and depressed.

· Dan Gaz is a graduate of Indiana University with degrees in both exercise science and applied sport science. A self-proclaimed Internet Renaissance man, Gaz is a jack-of-all-trades and a master of none.

Whether you need to fix, build, create or learn, eHow gives you practical solutions to the problems life throws at you. We empower you to efficiently solve each new challenge and make your life better and easier.

Walking belt not properly aligned. There are two holes on each side of the back covers of the treadmill. They have the adjustment bolts in them for the rear roller and It will require an Allen wrench to adjust it. If you tighten one of the bolts it causes the belt to move away from that side. So if it’s the left side of the belt that’s moving …

· The safety key would be clipped. I have a Precor C944 Treadmill. The safety key would be clipped in place, however the screen still requests the saftey key to run. If I work the safety key around in the key-dock, it may register for … read more. Hi I own a Precor M9.25 Treadmill which I have had for severL years.

· FreeMotion. in treadmill setting mode, Go to start menu. Go to the “I” icon button located at left corner of your screen. click maintenance mode button at the lower left corner. From the kinds of functions, choose to execute factory reset.